- Connection size***: 8 mm
- Connection type: Push-in
- Connection size: 8 mm
Blanking cap
Blanking caps for push-in fittings cover the end of a tube or an open connection in a compressed air system, so that no air escapes and no dirt or moisture gets in. They are meant for closing a line temporarily during assembly, maintenance or transport of a machine.
The caps in this category are white hose caps from SMC, from the KQ2C series, in Ø4, Ø6, Ø8, Ø10, Ø12 and Ø16 mm. The size is the outside diameter of the tube the cap fits on. So measure the tube rather than the fitting, and take one cap per open end. The white colour stands out between coloured tubes, so when you reconnect you see at a glance which line is still closed.
A cap is not the same as a push-in plug: the blanking plug goes into a free port of a fitting, while the cap closes the tube itself. Both fall under the instant links, together with the fittings, elbows and manifolds you use to build the network back up.
- Connection size***: 16 mm
- Connection type: Push-in
- Connection size: 16 mm
- Connection size***: 12 mm
- Connection type: Push-in
- Connection size: 12 mm
- Connection size***: 10 mm
- Connection type: Push-in
- Connection size: 10 mm
- Connection size***: 6 mm
- Connection type: Push-in
- Connection size: 6 mm
- Connection size***: 4 mm
- Connection type: Push-in
- Connection size: 4 mm