FISCHER 44121 nail anchor FNA II 6x25/5 with nail head electrolytically galvanised

Product description

The installation-friendly Hammerset anchor for multiple fixings.

The fischer nail anchor FNA II 6 with nail head is made of zinc-plated steel. The FNA II is set in a time-saving manner in the push-through installation with just a few taps of the hammer. The installed FNA II expands automatically under load. The cone is then pulled into the expansion clip and expands it against the hole wall. Above all, the fischer nail anchor FNA II 6 with nail head is suitable for fixing fire protection boards, wire and nonious hangers in internal areas.

• Hammerset installation saves time
• No reinforcement hits due to low anchorage depth This saves time and costs during series installation
• Expansion clip provides a firm hold
• ETA approval for multiple fixings
• Series installation possible with setting tool for the hammer drill. This saves time and costs
• The special active principle allows for a simple hammerset installation and, therefore, a short processing time
• The extremely short anchor depth prevents reinforcement hits, and creates the conditions for a trouble-free installation
• The optimised expansion clip ensures hold when placing in the drill hole, and prevents it falling out during overhead installations
• The massive shaft cross-section guarantees a high load-bearing capacity, thus offering an extremely high level of safety
• A range of head shapes allows for the fixing of wide-ranging fixtures, and for the ideal adaptation to suit the intended use

Suitable for

• The FNA II with nail head is suitable for push-through installation. The FNA II M6 is suitable for pre-positioned and pushthrough installation. The FNA II OE and Hare suitable for pre-positioned installation
• The installed nail anchor FNA II expands automatically under load. The cone is pulled into the expansion clip and expands it against the drill hole wall
• Available setting tools:FNA S-SBO to slip onto the drill,FNA S-SDS for series installation with a drilling hammer,FNA S-H for the manual installation of mounting rails

Building materials

Approved for:

• Concrete C12/15 to C50/60, cracked, for multiple fixings of non-structural applications

Also suitable for:

• Solid sand-lime brick
• Natural stone with dense structure
• Prestressed hollow-core concrete slabs

Application

• Fire protection plates
• Fire protection boards
• Ventilation systems
• Wire and nonious hangers
• Mounting rails
• Metal clamps
• Substructures made of wood and metal