Scope of delivery
- 88V Automotive Multimeter
- TL224 silicone measuring leads
- AC285 Long Reach crocodile clips
- TP220 measuring probes
- RPM 80 inductive RPM
- TPAK ToolPak magnetic suspension clip
- 80BK temperature measuring probe
- Two automotive backprobe pins
- Insulation-penetrating probe
- C800 durable carrying case
- Holster
- 9V battery (installed)
- Quick start guide
- CD with detailed operating instructions
Product description:
- A complete automotive diagnostic package with almost everything you need in an automotive multimeter
- The number of electrical systems in modern cars is steadily increasing.
- This increase is only getting stronger with the introduction of hybrid vehicles.
- As a result, the multimeter is perhaps the most important tool for fault detection and troubleshooting.
- The Fluke 88V has improved measurement and troubleshooting functions a greater accuracy for troubleshooting even more faults in both conventional vehicles and new hybrid vehicles.
New features for optimal functionality
- A built-in thermometer makes it easy to take temperature measurements without having to carry a separate instrument.
- Conductivity measurement for measuring coils
- Magnetic hanging clip (included in kit) for easy attachment and reading while leaving your hands free for other tasks.
- "Peak min/max" for recording intermittent events with a duration starting at 250 microseconds
- With its large-digit display and bright backlight with two levels of illumination, the Fluke 88V is significantly easier to read than the old Fluke 88.
Other features
- DC measurement with 0.1% accuracy
- 20,000 count mode (4-1/2 digit) with high resolution for accurate measurements
- Measures up to 1000 V AC and DC
- Current measurements of up to 10 A; 20 A for up to 30 seconds
- Built-in thermometer allows you to carry one less instrument (thermocouple included)
- Diode test for testing alternators
- Frequency up to 200 kHz and % duty cycle
- Resistance measurement and continuity test
- Speed measurements using an inductive sensor (included)
- Pulse width measurements per millisecond for fuel injectors
- Magnetic hang clip to attach the gauge to the vehicle, leaving your hands free for other tasks
- Min/Max-Average recording with Min/Max Alert for automatic recording of variations
- Peak Logging for recording transients with speeds up to 250 µs
- Relative mode for eliminating test lead resistance when measuring low resistance values
- Automatic and manual range setting for maximum flexibility
- AutoHold for recording stable measured values and preventing signals with noise
- Large display digits and bright white backlight with two illumination levels for improved legibility
- Analogue bargraph for recording changing or unstable signals
- Input Alert provides audible warning of input misuse
- Enhanced sleep mode consumes less power, extending battery life
- Battery door for quick battery replacement without having to open the housing
- 'Classic' design with new loose holster with integral storage compartment for measuring lead and probe
- The 10 mega-ohm input impedance does not stress circuits and is safe for computers
- Lifetime warranty
Safety standards
- The Fluke 80 V has been independently tested and complies with the 2nd edition of ANSI/ISA S82.01 and EN61010-1 CAT IV 600V/CAT III 1000V.
- The instruments can withstand impulses in excess of 8,000 V and reduce the risks posed by power surges and spikes.
