Tungsten carbide burrs with the PLAST cut are suitable for trimming and contour milling on a wide range of fibre-reinforced plastics (GRP/CRP)
They are particularly suitable for use on less hard glass and carbon-fibre-reinforced duroplastics (GRP and CRP<= 40 % fibre content) and fibre-reinforced thermoplastics
The PLAST cut (similar to PCD milling) minimizes delamination and fraying
Cylindrical burr with drill cut
Burrs with a drill cut (BS) allow combined drilling and milling work
Advantages:
Particularly suitable for GRP and CRP<= 40 % fibre content.
Minimized delamination and fraying due to the special cut that is similar to PCD mills.
Particularly suitable for use on machines and on robots.
Very low cutting force.
High feed rates.
The highly accurate concentricity enables impactfree working without creating chatter marks. This considerably reduces wear on the tool and tool drive.
