- Min. diameter: 1/8 inch
- Max. diameter: 2 inch
- Thread type: BSPT
Ridgid 11-R and 12-R thread cutter sets and cutting head sets in case
Ridgid thread cutter sets in a case are made for installers who thread steel gas pipe or water pipe on site. The range is built around two systems: the 11-R with closed dies and the 12-R with open dies, each in a carrying case you take along to the job.
First choose the thread standard your fittings and valves call for: BSPT or NPT. Both standards are tapered, but they are not interchangeable, so the wrong set leaves you with a leaking joint. Then look at the range of the set: from 1/8" to 2", from 3/8" to 1 1/4", from 3/8" to 2" or from 1/2" to 2", depending on which pipe diameters you thread every day. If you already own a set, replace worn heads with a cutting head set or a single cutting iron, and the handle and the case stay in use.
For finishing tapped holes and pipe ends, this category also holds tap insert sets and a tap and pipe insert set. These sets are part of Ridgid sets and kits, next to the Ridgid hole saw sets and pendulum saw blade packs for drilling and cutting before you thread.
- Min. diameter: 1/4 inch
- Max. diameter: 1/2 inch
- Quantity per set: 5
- Min. diameter: 1/2 inch
- Max. diameter: 2 inch
- Thread type: NPT
- Min. diameter: 1/8 inch
- Max. diameter: 2 inch
- Thread type: NPT
- Min. diameter: 3/8 inch
- Max. diameter: 1 1/4 inch
- Thread type: BSPT
- Min. diameter: 1/2 inch
- Max. diameter: 2 inch
- Thread type: BSPT
- Min. diameter: 1/2 inch
- Max. diameter: 1 1/4 inch
- Thread type: BSPT
- Min. diameter: 3/8 inch
- Max. diameter: 2 inch
- Thread type: BSPT
- Min. diameter: 1/8 inch
- Max. diameter: 5/8 inch
- Quantity per set: 5
- Min. diameter: 3/8 inch
- Max. diameter: 2 inch
- Thread type: BSPT
- Min. diameter: 1/4 inch
- Max. diameter: 1 inch
- Quantity per set: 8
- Min. diameter: 1/2 inch
- Max. diameter: 2 inch
- Thread type: BSPT
- Min. diameter: 1/4 inch
- Max. diameter: 11/32 inch
- Quantity per set: 3